QF150S; edition 2016-05; page 6 of 19
2.4. Control panel
In the Quattroflow 150S pump is operated with a 50 W brushless Panasonic motor. You can modify
the speed of the motor by the control panel on the top of the pump.
Main switch. Push to start – the panel lights up
Push to speed up (arrow bottom-up) or to speed
down (arrow top down)
Push "Green button" RUN, to start the pump
“MOD button“ Switch between rpm, effiency %,
motor power V
Display show: "rpm, %, V"
(max. speed 3.000 rpm)
Push the "Red button" STOP to stop the pump
Attention: The optimal motor parameter are set by the factory.
Only authorized and qualified personnel should change the parameter of the control panel!
Attention!
You must study the operating instructions of the PANASONIC–Motor before
you make any changes of the parameter!
Quattroflow 150S Pump
Motor: Panasonic, 50 W, 230V with integrated frequency inverter
Speed control: Panasonic Digital Control Panel
2.5. Cleaning (CIP)
Depending on the products in contact with the pump and given requirements the cleaning procedure
needs to be adapted accordingly. It is the responsibility of the user to verify the cleaning efficiency.
Safety rules and safety measures like protective glasses, gloves and protective clothing have to be
followed and used when working with chemicals like sodium hydroxide (NaOH).
As a general rule we recommend to clean the pump according to the following procedure.
1. Pre rinse the pump with pure water, until residual amounts of product have been removed.
2. Cleaning step with 0.5 M NaOH (ca. 50°C) at 80% of the maximum RPM for
approximately 30 min. Check before, if surrounding conditions (e.g. pipe diameter, system
pressure rating) allow to operate the pump at this speed.
3. Final rinse with pure water, until neutrality has been achieved (e.g. by measuring
conductivity or pH of the rinse water).
