HEIKO 010164xx
Quax nv
Karel Picquélaan 84 B-9800 Deinze Belgium
T
T
0032 9 380 80 95 www.quax.eu -
E
E
info@quax.eu
TO AVOID DANGER OF SUFFOCATION REMOVE PLASTIC COVER BEFORE USING THIS
ARTICLE. THIS COVER SHOULD BE DESTROYED OR KEPT AWAY FROM BABIES AND
CHILDREN.
The babybed is intended for children who cannot climb out the bed by themselves and as soon as this is the case remove
the cot from use.
Assemble the bed following the instructions hereunder.
Do not change the design and the assembly method of this bed.
1.
WARNINGS and USE
WARNING : DO NOT LEAVE THE CHILD UNATTENDED
IMPORTANT
- RETAIN FOR FUTURE REFERENCE
- READ CAREFULLY.
Introduction
: Before putting into use, check if all parts of the bed are in good condition, well tightened, and do not show
sharp edges which may injure the child or snag on its clothing (or cords, necklaces, paci
fi
er ribbons), causing a strangu-
lation hazard. Check all connection points.
Inspection
: Regularly check the bed for broken, warped or missing parts. No longer use the bed whenever such parts
are found.
Replacement of parts
: Allways use original parts, to obtain from the manufacturer or the distributor.
Base
: Do not use this bed without the base. The lowest position is the safest and the base should always be used in that
position as soon as the child is old enough to sit, kneel or to pull itself up.
Mattress
: We recommend a mattress of 120*60 cm. The thickness of the mattress must be so that the distance between
the upper side of the mattress and the upper side of the bed is minimally 500 mm with the base in the lowest position and
minimally 200 mm in the highest position. This last one indicated by the marking on the bed. Do not put two mattresses
one upon another.
Wheels
: If the bed is equipped with wheels with a brakesystem, allways block the wheels.
Objects over or in the bed
: Do not leave anything in the bed or place the bed near objects which could provide a foot-
hold or create a danger of su
ff
ocation or strangulation. Do not hang anything on or over the bed, do not place anything
against the bed.
Fire hazard
: Do not place the bed near a heat source such as electrical heating, gas heating, etc. in order to avoid any
fi
re hazard.
Maintenance
: Only clean the bed with soap or any other mild cleaning agent without toxic components and with warm
water.
To get beautiful and undamaged furniture work carefully.
Use a clean blanket and remove any screws or the like.
This assembly is better done with two people.
Work slower and your satisfaction will be better.
8
