PiXtend V2 -L- Hardware Manual
Most of the plug-in power supplies are equipped with a female connector socket 2.1 mm
(inside) x 5.5 mm (outside). This means that connection to the terminals on PiXtend V2 -L-
is not possible directly.
We therefore have put together a set which contains all the required individual lines for the
connection to PiXtend (Fig. 37). The set can be ordered in our
o
nline
s hop
.
The set contains the following components:
•
Plug-in power supply - fixed output voltage - 24 V DC, 1.04 A
•
Adapter from female socket to terminal blocks
•
Connection leads red and blue - 0.75 mm², 10 cm length
The adapter is plugged into the female connector socket. The two leads can be plugged
into the adapter without tools. To do this, the actuating button of the adapter must be
pressed down.
Connect the red wire (+) to the connector with the red actuating button, and the blue wire
(-) to the connector with the black actuating button:
www.pixtend.com
Copyright by Qube Solutions GmbH
54 / 146
Figure 38: Connect the cables to
the adapter
