EN
.
11
2.3. Additional features of Flush 2 Relay which can make your life easier
•
Do you worry that your irrigation system
can expose your garden to flooding?
•
Sometimes your Z-Wave gateway (hub)
can stop working while you’re away from
home (no internet connection, power
outage, etc). If you have an irrigation
scene scheduled, your gateway (hub)
might not send an OFF command to your
irrigation system, leaving your garden
flooded and water bill more expensive
than you’d like. The
Flush 2 Relay offers
the option to set the timing for irrigation
for a specific amount of time internally; it
then automatically stops watering,
completely
independent
of
your
g
ateway’s (hub’s) commands.
For the 24VDC use case, please check the chapter above.
•
Do you often forget to turn off devices
when you leave your home, like lights in
the basement or attic?
•
The Flush 2 Relay can automatically turn
devices/lights on or off after a set period
of time (when you’re away from home).
For example, the lights will automatically
turn off if it’s been on for 8 hours, let’s
say. This function is independent of
other scenes and gateway (hub)
commands.
Summary of Contents for Flush 2 relay
