EN
.
62
COMMAND_CLASS_SWITCH_MULTILEVEL_V3
COMMAND_CLASS_ASSOCIATION_V2
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V3
COMMAND_CLASS_ASSOCIATION_GRP_INFO_V2
COMMAND_CLASS_MARK
COMMAND_CLASS_SWITCH_MULTILEVEL_V3
Endpoint 3:
Device Class:
GENERIC_TYPE_SENSOR_MULTILEVEL
SPECIFIC_TYPE_ROUTING_SENSOR_MULTILEVEL
Command Classes:
COMMAND_CLASS_ZWAVEPLUS_INFO_V2
COMMAND_CLASS_SENSOR_MULTILEVEL_V7
COMMAND_CLASS_ASSOCIATION_V2
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION_V3
COMMAND_CLASS_ASSOCIATION_GRP_INFO_V2
NOTE: The Endpoint 3 command class list only applies if an external digital temperature sensor
(sold separately) is connected to the TS terminal. If the sensor is not connected, the following
command class is not supported by the device:
COMMAND_CLASS_SENSOR_MULTILEVEL_V7
Endpoint 2 is supported by the module only when the parameter no. 71 is set to the value 1 and
the module is excluded and re-included into the network.
This product can be included and operated in any Z-Wave network with other Z-Wave certified
devices from any other manufacturers. All constantly powered nodes in the same network will
act as repeaters regardless of the vendor to increase reliability of the network.
Summary of Contents for Flush Shutter
