EN
.
62
14. Technical Specifications
Power supply
110 -
230 VAC ±10% 50/60Hz
*, (24-30VDC)
Rated load current of AC/DC output
(resistive load)*
0,6A / 230VAC /
0,85A / 30VDC
Output circuit power of AC/DC
output (resistive load)
140W (230VAC) /
21W (24VDC)
Power measurement accuracy
+/-2W
Digital temperature sensor range
-50 ~
+125°C (
-
58 ~ 257°F)
Operation temperature
-
10 ~ +40°C (14 ~ 104°F)
Z-Wave operation range
up to 30mindoors (98 ft)
Dimensions (WxHxD) (package)
41,8x36,8x16,9 mm (79x52x22 mm) / 1,65x1,45x0,66 in
(3,11x2,05x0,87 in)
Weight (with package)
28g (34g) / 0.98oz (1.20oz)
Electricity consumption
0,7W
For installation in boxes
Ø ≥ 60 mm (2,36 in)
or 2M,
depth≥ 60 mm (2,36 in)
Switching
MOSFET (Trailing edge)
Z-Wave Repeater
Yes
* 50Hz for ALL ORDERING CODES; 60Hz for ZMNHDD3
Maximum Power Limit is automatically set by the device
’s
software. If maximum power is
exceeded for more than 5 seconds, the dimmer will turn off until the next power cycle. When
overload occurs, an
“Over
-
load detected”
notification is sent to the gateway (hub).
Power consumption in kWh is reported in 0.1kWh intervals.
Summary of Contents for ZMNHDD2
