EN
.
34
13. Flush RGBW Dimmer Mode Descriptions
NORMAL MODE:
1.
Momentary switch type
Controlling output (Q is defined as output) assigned to given input terminal. In this setting
outputs will be controlled independently from one another, e.g. allowing for free adjusting each
colours saturation.
NOTE:
Q1 on the device is marked as
Red
Q2 on the device is marked as
Green
Q3 on the device is marked as
Blue
Q4 on the device is marked as
White
INx
(for orientation this function is set on IN4 by default)
•
Fast press
on input INx (less than 1 second) -
> turn the Qx to the “last non zero
dimming value”
o
Dimming time depends on Parameter no. 12 value.
•
Fast press
on INx -> turn Qx OFF
o
Dimming time depends on Parameter no. 12 value.
•
Press and hold (more than 1 second)
-
> increase brightness on Qx and set new “last
non zero value” for Qx
o
Dimming time depends on Parameter no. 13 value.
•
Press and hold (more than 1 second) -> decrease brightness on Qx
-> decrease
brightness on Qx and set new “last non zero value” for Qx
o
Dimming time depends on Parameter no. 13 value.
•
Fast double click
->
turn the Qx to “MAX dimming value” (Parameter no. 10)
o
Dimming time depends on Parameter no. 12 value.
Summary of Contents for ZMNHWD2
Page 10: ...EN 10 Remotely dim up to 4 LED bulbs or turn them ON OFF...
Page 16: ...EN 16 4 Package Contents Flush RGBW Dimmer Device Installation Manual...
Page 22: ...EN 22 After Qubino installation...
Page 23: ...EN 23 INSTALLATION EXAMPLE Controlling four halogen or LED lights...
