QUERIDOO Q6000A, User Manual

Sportrex2 – Q6000A

Subject to change. – 02|2016 – 

31

Maintenance intervals

Caution!

Replace corroded steel and aluminium parts immediately.  

Never bend back deformed or bent aluminium parts (risk of breakage). Replace 

bent aluminium parts immediately. 

Immediately replace plastic parts that have become porous or fragile due to the 

effects of the weather, for example.

Before every ride

ƒ

Check that the wheels are secure. The push-in axles must be engaged in the axle mount and it 

must not be possible to pull them off without pressing the rubber cap.

ƒ

Check the air pressure in the wheels. It should be in the range of 1.7 – 2.4 bar.

ƒ

Check the air pressure of the buggy wheel (maximum air pressure: 2 bar).

ƒ

Check the total weight, including children and baggage. A maximum of 60 kg is allowed.

ƒ

Check the fasteners of the cover and close them if necessary. 

ƒ

Inspect all harnesses on the back and under the cabin to make sure that they are secure. 

They must be firmly tightened to hold the cover and backrest securely.

ƒ

Trailer mode: Make sure that the buggy wheel has been removed and that the requirements 

described in the chapter 

“Connecting the trailer to a bicycle” on page 26

 have been fulfilled. 

ƒ

Buggy mode: Make sure that the buggy wheel can rotate freely. Put the hand strap of the push 

handle around your wrist in order to prevent accidental rolling away.

ƒ

Walker mode: Make sure that the buggy wheel is secured facing straight ahead. Put the hand 

strap of the push handle around your wrist in order to prevent accidental rolling away.

Monthly (or every 200 km)

ƒ

Check the textile cover, all fasteners, the seats and the safety harnesses for cracks, wear and 

missing parts. 

ƒ

Inspect all frame tubes and all connecting pieces and fastening components for signs of wear 

and damage. 

ƒ

Check whether the tow bar, coupler and buggy wheel and their attachments are technically 

OK.

ƒ

Check that all screw and cotter pin connections are secure.

ƒ

Check the condition of the wheels. Replace covers and hoses in good time.

Semi-annually (or every 500 km)

ƒ

Care for all sliding and moving parts with silicone spray.

ƒ

Clean the inside and outside of the cabin thoroughly. 

Every three years (or every 3000 km)

Have a full inspection carried out by a specialist workshop no later than every three years. 

Care and maintenance