DR4300 Owners Manual
Installing an expansion card into the expansion card riser 2 or 3
103
See also:
After working inside your system
Related references
See also:
Installing an expansion card into the expansion
card riser 2 or 3
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
CAUTION:
Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is not
authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are
shipped with your product.
1. Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. Lift the expansion card latch and remove the filler bracket.
3. Holding the card by its edges, position the card so that the connector on the expansion card aligns with the
expansion card connector on the riser.
4. Insert the card-edge connector firmly into the expansion card connector until the card is fully seated.
5. Press the touch points to open the expansion card locking tabs.
6. Close the expansion card latch.
7. If applicable, connect the cables to the expansion card.
NOTE:
When installing a GPU card on riser 2 or riser 3 (default), connect the GPU card power cable
to the power connector on the riser.
Figure 33. Installing an expansion card into the expansion card riser 2 or 3
Summary of Contents for DR4300e
Page 1: ...DR4300e System Owner s Manual ...
Page 181: ...DR4300 Owners Manual 181 Index ...
