1-800-533-7533
Quest
DRY
70
Installation, Operation and Maintenance Instructions
3
www.QuestProtect.com
sales@QuestProtect.com
quest
quest
Safety Precautions
Read the installation, operation and maintenance instructions carefully before installing and operating
this device. Proper adherence to these instructions is essential to obtain maximum benefit from your
Quest DRY 70.
READ AND SAVE THESE INSTRUCTIONS
• The device is designed to be installed
INDOORS IN A SPACE THAT IS
PROTECTED FROM RAIN AND FLOODING.
• Install the unit with space to access the front panel for maintenance
and service.
DO NOT INSTALL UNIT WITH THE FRONT PANEL
INACCESSIBLE.
• Avoid directing the discharge air at people, or over the water in pool
areas.
• If used near a water source; be certain there is no chance the unit
could fall into the water or get wet. The unit should also be plugged
into a GFCI (Ground Fault Circuit Interrupt) outlet.
• DO NOT
use the device as a bench or table.
• DO NOT
place the device directly on structural members.
• A drain pan
MUST
be placed under the unit if installed above a living
area or above an area where water leakage could cause damage (see
local regularity code for more information).
• Never operate a unit with a damaged power cord. If the power cord is
damaged it must be replaced by the manufacturer, its service agent, or
similarly qualified person in order to avoid a hazard.
• The unit shall be installed in accordance with national wiring
regulations.
• Do not obstruct the air intake and exhaust. Maintain a .3 m (1 ft)
clearance around the air intake and exhaust.
• This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not
play with the appliance.
FOR HVAC INSTALLER AND OWNER
