Cable
: indicate the modulation standard of this device is DVB-C.
A
: the symbol of different carrier output. “
A
”, “
B
”, “
C
”, and “
D
” alternate
constantly with the following output frequency.
XXX.XX MHz
indicates the current output frequency (range: 30~960MHz) of its
corresponding carrier output.
X.XX Mbps
: indicate the encoding bit rate of the 2 SDI programs respectively.
3.3 General Settings for Main Menu
Press “Lock” key on the front panel to enter the main menu. The LCD will display the
following pages where user can configure the parameters for the device:
User can press UP/DOWN buttons to specify menu item, and then press ENTER to
enter the submenus as below:
1)
Alarm Status
The alarm indicator will turn on if there is no A/V signals inputting or outputting bit
rate overflows. User then can enter this menu to check the error type.
2)
Encode Setting
Under this submenu, the LCD will show “2.1 Input 1”, “2.2 Input 2” and “2.3 ASI”.
Under submenus 2.1 or 2.2, user could set the video encoding format and bit rate, and
set audio encoding bit rate and also read the audio encoding format of the program from
1 Alarm Status
2 Encode Setting
3 Modulate Setting
4 IP Output Setting
5 Network Setting
6 Saving Config
7 Loading Config
8 Version
2.1 Input 1
2.2 Input 2
2.3 ASI
SDI Encoder Modulator
User Manual
B-QAM-SDI-IP-2CH-LL
www.questtel.com
sales@questtel.com