44
MANUAL DE USUARIO
3. Starting up
3.1. Preparation of the pool water
3.1.1. How to add salt to your pool
The
QUICKSALT
salt chlorinator requires a small concentration of common salt (NaCL) to work
properly. The recommended concentration is between 4000ppm and 8000ppm with the most
common concentration being 5000ppm.
We recommend the use of specific salt for salt chlorinators, which you will find in shops
specializing in swimming pool products.
Add the salt directly to the vessel of the pool. It is recommended to add it progressively, in 2-3
times, waiting for it to dissolve before adding a new quantity.
To calculate the salt to incorporate in your pool, the following example is shown:
Note:
Use only pool-specific salt of greater than 99% purity, with no iodine
content..
Note:
You can speed up the dissolution by running the filtration pump, but it
is highly recommended not to let salt accumulate in the pool drain, to avoid
damaging the pump. We recommend that you pour the salt near the edges of
the pool.
Important:
If you are going to start the pump before the salt is completely
dissolved, we recommend that you stop the QUICKSALT equipment. To do
this, press and hold the button, OK, until you see the message “stand-by” on
the screen.
POOL 9M LONG, 4M WIDE AND 1.6M DEEP ON AVERAGE
The amount of salt to be incorporated will be 5Kg/m3 to obtain a concentration of 5000ppm.
9 x 4.5 x 1.6 = 64.8m3 x 5 = 324 Kg of salt to be incorporated.
Summary of Contents for e-360
