USER MANUAL
5
2.5.
Setting and Operation
CAUTION: Please check the power supply is according to the
rating voltage on the nameplate of the device before installing the
solder station.
5.1 Iron Holder and Sponge
The sponge is compressed. It will swell when
moistened with water. Before using the unit,
moisten the sponge with the water and
squeeze it dry. Failure to do so may result in
damage to the soldering tip.
If the sponge becomes dry during working,
add appropriate water.
1.
Dampen the small cleaning sponge with water and then squeeze it
dry.
2.
Place it in groove of the iron holder base.
3.
Add a little water to iron holder. The small sponge will absorb water
to keep the large sponge around it wet at all times.
Dampen the large cleaning sponge and place it on the iron holder base.
5.2 Connection
CAUTION:
Be sure to turn off the power switch before
connecting or disconnecting the soldering iron. Failure to do so
may damage the soldering station.
1.
Connect the connector of the handle cord to the socket behind the
unit. Take notice of inserting position about connector.
2.
Place the soldering iron at the iron holder.
3.
Insert the power plug into grounded power socket.
4.
Turn on the power switch.
