Quick BGA2100, Manual

●

Aligning arm is controlled by the “CAMERA” key. Pressing “CAMERA” key, 

when the aligning arm is in side, it will move automatically from inner to outer 

and stop in one line with the top heater, and when the aligning arm is outside, it 

will do the opposite action to the initial state. But the aligning arm does not act 

when pressing it until the top heater up to the top.

●

Aligning arm is outside when the camera in using state and the light of the 

camera is adjustable. User can get a clear image by lighting, focusing and 

zooming and the aligning operation is easy and convenient by micro adjusting. 

8. 

Nozzle Instruction

●

The nozzle will act during the process of placing and sucking the chip and the SUCKER key and 

the rocker can control the nozzle’s movement.   

●

Press “SUCKER” key to the state of the chip sucking and the nozzle will suck the chip 

automatically.  

●

Press “START” key to the state of the chip pasting and the nozzle will paste the chip 

automatically.  

●

Turn the rocker when optics alignment to make the BGA sucked by the nozzle turning until the 

stannum ballpoint in the BGA is superposable with the cuprum point in the PCB. During the 

process, make the rocker leftward and rightward, onward and backward for precise alignment. 

Note: 

the communication is unilateral, and the saving data in the small LCD cannot transfer to the 

PC, but the data saved in the PC can transfer to the small LCD.

9.

Functions and use of the software 

a)

Installation 

Before use the “BGAQuickSoft” software, it must be installed in the computer. Double click the icon of the 

“BGAQuickSoft” in the CD, and then install the software as the program. 

b)

Login 

1. After install successfully, it will pop up an interface of inputting password as following: 

Page 8