21
GB
DYLAN DH 1500/1700/2000W - REV001A
21
MAINTENANCE
WARNING:
make sure the electrical power to the motor is
switched off when working manually on the windlass. Care-
fully remove the chain or rope from the gypsy or the rope
from the drum.
Quick
®
windlasses are manufactured with materials resistant to
marine environments. In any case, any salt deposits on the outside
must be removed periodically to avoid corrosion and damage to the
equipment.
The parts where salt may have built up should be washed thor-
oughly with fresh water.
Once a year, the drum and the gypsy are to be taken apart as follows:
DRUM VERSION
Use the handle (1) to loosen the bush (7); pull off the drum (6) and
the top clutch cone (8); loosen the fixing screws (11) of the rope/
chain stripper (12) and remove it. Pull off the gypsy (9).
NO-DRUM VERSION
Use the handle (1) to loosen the bush (2) and the screws (5); to
remove the gypsy cover (4); and the top clutch cone (8); loosen the
fixing screws (11) of the rope/chain stripper (12) and remove it. Pull
off the gypsy (9).
Clean all the parts removed to avoid corrosion, and grease the shaft
thread (18, 19, 20 or 21) and the gypsy (9) where the clutch cones
rest (7 and 9) (use grease suitable for marine environment).
Remove any oxide deposits from the terminals of the electric motor
and the contactor unit; grease them.
51
Terminal board gasket 1000W
PCGPMMR00000
52
Terminal board cover 1000W
PCCPPMMR0000
53
Screw
MBV02213AXSC
54
Bottom gasket 1000W
PGGPMFN00000
55
Bottom protec cover 1000W
PCCPPMFN0000
56
Cable outlet
PPM20B000000
57
Gearbox 2000W - Quick series
SLMR20TG7000
58
Screw
MBV0825MXE00
59
O-ring - gearbox 2000W
PGR025980000
60
Watertight motor casing 2000/2300W PCCCPM200000
61
Key 6x6x30
MBH0606030X0
62
Electric motor 2000W 24V
EMF202400000
63
Bottom cover O-ring
PGR035250000
64
Bottom cover
PCCPPMFN2000
65
Lower terminal board gasket
PCGPMMR2N000
66
Upper terminal board gasket
PCGPMMR2S000
67
Upper terminal board cover
PCCPPMMR2000
68
Self-tapping screw M3.9x22
MBV03922AXCC
69
Self-tapping screw M3.9x32
MBV03932AXCC
70
Gearbox flange gasket Top TG60
PGFLRDTG6000
71
Gearbox flange gasket Top TG70
PGFLRDTG7000
72
O-ring - bush
PGR031500000
POS.
DESCRIPTION
CODE
1
Bent anchor winch lever
ZSLMSHR10000
2
Chrome-plated “DN” clutch bush
SGMSD1500000
3
O-ring
PGR033000000
4
Gypsy cover
SGMSGB10AL00
5
Screw M5x16
MBV0516MXCE0
6
Drum
SPMSE15DNR01
7
Chrome-plated “DN” clutch bush
SGMSDCPDN150
8
Upper clutch cone
SLMSF15DND00
9A
Gypsy 1500W 10mm - 3/8"
ZSB151038000
9B
Gypsy 1500W 12/13mm
ZSB151213000
10
Bottom clutch cone
SLMSF15DNN00
11
Screw 6x35
MBV0635MXCE0
12
Chrome-plated rope/chain stripper MSNDN0000000
13
Spring washer
MBR307025X00
14
Oil seal 30x55x10
PGPRL3055100
15
Internal circlip
MBAN5520Y000
16
External circlip
MBAE3015Y000
17
Bearing
MBJ600600000
18
Oil seal 30x50x7
PGPRL3050070
19
Short Shaft 1500W
MSAS15367R00
20
Short Shaft 1700/2000W
MSAS20367R00
21
Long shaft 1500W
MSAS15411R01
22
Long shaft 1700/2000W
MSAS20411R01
23
Key
MBH0807140X0
24
“DH” chain fall cover
-
25
Screw
-
26
“DH” chain guide support
SGMSN15DN000
28
Molla tendicima
MMTC15DNC000
27
Mooring rope puller pin
-
29
Pressure lever
PDLVTD150000
30
Gypsy lock spring
MMBLBRATC000
31
Gypsy lock lever
MSH10ATCX000
32
Gypsy lock lever control
MSVLBBATCX00
33
Lever lock control safety
PDSCLVBB0000
34
Gypsy lock pin
MSVPR10ATC00
35
DH base
-
36
Gasket / jig DYLAN DH
-
37
Sensor Reed
KNREEDCL0000
38A
Stud 8x80
MBP080807X00
38B
Stud 10x110
MBP101100X00
39A
Washer 1500W
MBR08X000000
39B
Washer 1700/2000W
MBR10X000000
40A
Spring washer 1500W
MBR08XDE0000
40B
Spring washer 1700/2000W
MBG10X000000
41A
Nut 1500W
MBD08MXEN000
41B
Nut 1700/2000W
MBD10MXEN000
42
Insert for manual anchor weighing PDRM15000000
43
Gearbox
1500W - Quick series
SLMR15TG7000
44
Washer
MBR061815X00
45
Self-locking nuts
MBD06MXET000
46
O-ring - gearbox 1500/1700W
PGR023000000
47
Gearbox 1700W - Quick series
SLMR17TG7000
48
Key 5x5x15
MBH050515F00
49A
Electric motor 1500W 12V
EMF071200000
49B
Electric motor 1700W 12V
EMF101200000
49C
Electric motor 1700W 24V
EMF102400000
50
Motor casing watertight 1500/1700W PCCCPM100000
