QUICK EA-A10 OPERATION MANUAL
Page 10
8.3
De-soldering Process
Note: please check the flow type “deso” before running the de-soldering process.
The counterpoint in the middle of desolder chip
Run the flow D1~D6
If the temperature of
the PCB still is too
higher
Press “STOP”
The flow of COOL finishes.
Press “STOP”
Click “COOL FAN” key to open the cool fan
End
Start desolder
The moving arm will
move slowly when near
the chip
Run the vacuum automatically
and suck the chip before 20
seconds ending the flow D6.
Are there abnormal cir
s
during
the
process D1~D6?
NO
The flow of D1~D6 finishes.
YES
Select desolder in software
Select flow in software interface
It comes to the COOL flow after
the flow D6, and the cool fan
comes to blow and cool the PCB.
And the time, the moving arm
will move up some distance.
After the COOL flow ends, the
moving arm will move up to top
and back to origin.