33
EN
INSTALLATION AND USE MANUAL
QUICK MC²X 16k - 16k LV
- REV001E
16k - 16k LV
2 - Supplied parts
MC
2
X Quick
gyro stabilizer is equipped with all the parts needed for its installation.
2.0 - Package contains the following parts
1
Pre-wired
MC
2
X 16k - 16k LV Gyro stabilizer
1 Power cable
(6 m long)
1 AC DYNAMIC CONTROL MC
2
X Driver
to control and operate the gyro
1 J1
Extention CAN BUS
(6 m long)
1 J2
Extention CAN BUS
(6 m long)
1 J5
Extention CAN BUS
(6 m long)
4 Eye bolts
for
MC
2
X 16k - 16k LV
stabilizer lifting
1 Template t
o install the
MC
2
X 16k - 16k LV
stabilizer
1 Template
to install the
AC DYNAMIC CONTROL MC
2
X
driver
INSTALLATION AND USE MANUAL
The warranty
2.1 - Needed accessory and material included in its packaging
Not supplied with the stabilizer
• RC Remote Control MC
2
X
touch, 4" and 5", IP66 - It allows you to turn the stabilizer on and off
and monitor its status ( also in multi-station).
Supplied with:
- template for mounting the Remote Control
- J3 RC Extention CAN BUS
for the CAN BUS connection to the
RC Remote Control MC
2
X
- CAN 5P T F/F/F connector
- CAN Terminator.
2.2 - Required components, not supplied with the stabilizer
• Differential circuit breaker for connecting the AC DYNAMIC CONTROL driver.
• Screws with resistance category higher than 8.8. Tightening torque
70 Nm - M10
.
2.3 - Tools needed for installation
• Lifting straps
• Torque wrench
• Drill & drill bit 11 mm (7/16")
• Fork key 17 mm (21/32")
• Hexagonal key 8 mm (5/16")
