16
INSTALLATION AND USE MANUAL
QNN
- REV000A
EN
10 - Using the control interface
10.1 - Keys and functions
The functions of the QNN described are only available for products
Quick
®.
The interface must be used to switch on the
Quick®
compatible products.
The Gateway QNN must be connected to the interface inlets through clean contacts.
The product(s) to activate through the interface must be previously installed and connected to the mains or the
battery.
To make instructions easier, all functions and symbols are indicated in the figure.
However, while using the device, the display only shows the icons and display areas relative to the connected functions.
The detailed instructions for use can be found in the following.
*In “Home” it shows the general settings; in each page it shows the settings for the page shown
QNN ICON
10.0 - Start QNN
After performing the installation procedure, including the electrical connection of the Quick products, the
QNN icon will appear on your Chart plotter screen. Pressing it opens the programme and you can start
using it right away.
Use of the QNN interface does NOT replace the control panels dedicated to the Quick products. The interface must be
used with full knowledge of the facts and to facilitate the functions of the connected Quick products.
If bugs are encountered in the QNN interface, use the specific control panels for each product.
F
F
a
a
m
Gyro 1: Speed 0%
HOME
ICON - FRAME
QUICK ACCESSORY
ACCESSORY STATUS
HOME
SETUP*
INFO POINT
ALARM/ERROR
MENÙ
F
