20
INSTALLATION AND USE MANUAL
QNN
- REV000A
EN
10 - Using the control interface
Press to Lock
It is possible to weigh/drop the anchor using the Quick electric commands; the QNN will measure the length of the chain
dropped.
WARPING MODE - ACTIVE ONLY WITH PCS
NR
DESCRIPTION
OPERATION
1
Status
This area shows messages related to the status of the instrument.
2
Raise chain key (Red)
Hold down the key to raise anchor
3
Drop chain key (Green)
Hold down the key to drop anchor
4
Zero set key
Reset the measure of chain lowered.
This option is to be used during
installation or when the chain counter’s reading does not match the actual length of the
chain lowered.
5
Setup Anchoring
1. Setting for choice of meters of chain to use.
2. Time out: Automatic disablement with command enabled. The time out occurs after
the time set in the time out parameter since the last command was executed (default
10 minutes).
6
Block functions key
Command Enable and Block key (hold down to block or unblock the control).
7
Capstan
Key to pass to warping mode, use (external) commands.
8
Chain
Key to pass to windlass mode
F
8
More information
- Manual PCS - CHC 1203
