Section 8 – Tail Assembly
Parts List
Tail boom
Belt
Boom holder half x 2
M3x35 x 4
M3 Locknut x 4
Tail output shaft
Pulley gear
M3 set screw x 2
Tail case side plate x 2
5x10x4R Bearing x 2
Tail pitch lever base
M2x6 Pan head screw x 2
M3x6 Cap head screw x 6
Tail Pitch Slider
M3x4 Pivot Stud
2.3 Medium ball ends
Tail Pitch Lever
M3x4 Pivot stud
M3x10 Cap head screw
M3x3 Set screw
Tail rotor hub
Tail blade grips x 2
3x7x3R Bearing x 2
M3x6 cap head screw x 2
M2x8 Pan head screw x 2
Shim ball x 2
Tail blades x 2
M3x20 Cap head screw x 2
M3 Locknut x 2
Tail blade spacers x 4
Locate the tail boom and the belt.
Slide the belt through the boom. Be
sure you do not twist the belt.
Install the two boom halves into the
frames. Put the (4) M3x35 cap head
screws through the four open holes in
the boom halves. Loosely put the nuts
on the ends of the bolts.
