Section 6 – Tail Assembly
Parts List
Tail boom
Belt
Boom holder half x 2
M3x35 x 4
M3 Locknut x 4
Tail output shaft
Pulley gear
M3 set screw x 2
Tail case side plate x 2
5x10x4R Bearing x 2
Tail pitch lever base
M2x6 Pan head screw x 2
M3x6 Cap head screw x 6
Tail Pitch Slider
M3x4 Pivot Stud
2.3 Medium ball ends
Tail Pitch Lever
M3x4 Pivot stud
M3x10 Cap head screw
M3x3 Set screw
Tail rotor hub
Tail blade grips x 2
3x7x3R Bearing x 2
M3x6 cap head screw x 2
M2x8 Pan head screw x 2
Shim ball x 2
Tail blades x 2
M3x20 Cap head screw x 2
M3 Locknut x 2
Tail blade spacers x 4
Locate the tail boom and the belt. Slide the belt
through the boom. Be sure you do not twist the
belt.
Install the two boom halves into the frames. Put
the (4) M3x35 cap head screws through the four
open holes in the boom halves. Loosely put the
nuts on the ends of the bolts.
22
