54
BETRIEB
D
Taste ON/STAND-BY:
Anhand dieser Taste kann das Batterieladegerät in den Standby-Zustand versetzt werden. Um die Stan-
dby-Modalität zu aktivieren, muss die Taste schnell gedrückt werden (das Drücken und Loslassen muss
in weniger als einer Sekunde erfolgen). Um die Standby-Modalität zu verlassen, muss die Taste schnell
gedrückt werden. Andernfalls kann das Batterieladegerät auch vom Wechselstromnetz abgetrennt und
wieder angeschlossen werden.
Durch die Leuchtdioden wird folgendes angezeigt:
BEDIENUNGS DISPLAY
Die Steuertafel besteht aus drei Leuchtdioden, 7 stellige Segment Anzeige und taste:
LED POWER, LED LADUNG PHASE
(BULK, ABSORPTION, FLOAT),
LED FEHLER
,
STATUS
anzeige und
taste
ON/STAND-BY
(siehe Abb 4).
LED POWER
LED LADUNG PHASE
(BULK, ABSORPTION, FLOAT)
LED FEHLER
BESCHREIBUNG
Leistungsabgabe unterbrochen.
BULK-Phase
- Ladung bei Konstantstrom
ABSORPTIONS-Phase
- Ladung bei Konstantstrom
FLOAT-Phase
- Haltebelastung
BULK-Phase
- Ladung bei Konstantstrom-Digitalsteuerung parallelgeschaltete Einheiten aktiviert
ABSORPTIONS-Phase
-
Ladung bei Konstantstrom -Digitalsteuerung parallelgeschaltete Einheiten aktiviert
FLOAT-Phase
- Ladung bei Konstantstrom-Digitalsteuerung parallelgeschaltete Einheiten aktiviert
FARBE LED
Aus
Grün
Blinkmodus
BESCHREIBUNG
Netzspannung nicht vorhanden
Netzspannung vorhanden
Batterieladegerät in Stand-by
ABB. 4
FARBE LED
Aus
Rot
Orange
Grün
Rot
Orange
Grün
ZUSTAND LED
-
Dauerlicht
Dauerlicht
Dauerlicht
Blinkend
Blinkend
Blinkend
FARBE LED
Aus
Rot
BESCHREIBUNG
Kein Problem bei manueller Rückstellung
Problem bei manueller Rückstellung (siehe Fehlercode)