XRSeries
EN
QUICK
XRSeries
INSTALLATION AND USER’S MANUAL - REV000A
8
3 - Introduction
BEFORE USING THE PRODUCT, PLEASE READ THIS USER’S MANUAL CAREFULLY. IF IN DOUBT, PLEASE CONSULT YOUR QUICK
®
DEALER.
3.0 - Important notes
This manual features Warning and/or Caution symbols that are important for safety.
Please follow the instructions provided.
Warning
symbol for dangerous
situations.
Caution
symbol to prevent direct or
indirect damage to the product.
This document provides boat manufacturers and nautical equipment installers with instructions on how to assemble the Quick
®
product and operate it correctly.
3.1 - Precautions
Quick® windlasses have been designed and manufactured to weigh the anchor
• Do not use these products for any other type of operation.
• Quick
®
shall not be held liable for direct or indirect damage caused by improper use of the product.
• The windlass is not designed to support loads generated in particular weather conditions (storm).
• Operate the product from a position where it is possible to supervise the work area.
• Always deactivate the windlass when not being used.
• Make sure that there are no bathers nearby before dropping the anchor.
• For improved safety, we recommend installing at least two controls to operate the windlass in case one is
damaged.
• We recommend the use of Quick
®
switch as motor safety device.
• Secure the chain with a retainer before sailing off.
• 24 V MODEL ONLY:
The reversing contactor box must be installed in a position protected from any water entry.
•
After completing the anchorage, secure the chain to fixed points such as chain stopper or bollard.
• To prevent accidental releases, the anchor must be secured. The windlass must not be used as sole securing
device.
•
Isolate the windlass from the electrical system during navigation and secure the rope to a fixed point of the boat.
• This equipment is not intended for use by people (including children) with reduced physical, sensory or mental
capabilities. Quick
®
SpA shall not be held liable for direct or indirect damage caused by improper use of the
equipment.
3.2- Precautions for the installer
CARRY OUT THE INSTALLATION IN GOOD LIGHTING CONDITIONS.
It is advisable to wear suitable clothing and personal protective equipment (PPE).
The product is not suitable for installation in potentially explosive environments and/or atmospheres.
Installation and subsequent inspection or repair work must only be carried out by qualified personnel.
CARRY OUT INSTALLATION/MAINTENANCE WORK MAKING SURE THAT THE PRODUCT IS DISCONNECTED
FROM THE ELECTRICAL SYSTEM.
Quick accepts no responsibility for inadequate connection of users to the electrical system and inadequate safety
of the electrical system.
