6
QUICK SPA
CHARACTERISTICS / INSTALLATION
GB
DIMMER ZDIM100 - REV001A
CONNECTING THE DIMMER
Dimmer ZDIM100 is a device specially designed to vary the light intensity produced by incandescent lamps and LED lamps.
Any other use is incorrect. Quick S.P.A. cannot be prosecuted for any damage due to an incorrect installation or an incorrect
connection or an incorrect use of the device. The correct installation, connection and use is described in the present paper.
WARNING
• Do not over load ZDIM100. The load factor cannot be higher than the maximum described in the Label Data below.
• Connect the polarities as described in the Connection Diagrams below.
• Do not install ZDIM100 in proximity of DC fluorescent lamps.
• Push Buttons must be connected by double-wire cables.
• Use separate cables to supply ZDIM100 and the lamps connected to it.
• ZDIM100 must be installed in proper ventilated places and kept out from heat and humidity.
Quick S.p.A. will not be responsible in case of wrong connection and misuse of this dimmer.
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE DIMMER.
IN CASE OF DOUBT, CONTACT YOUR DEALER OR QUICK
®
CUSTOMER SERVICE.
THE PACKAGE CONTAINS:
ZDIM100 - conditions of warranty - the manual of installation and use.
F
INSTALLATION AND CONNECTION DIAGRAM
Installation
with screw
Connecting terminals
Good to ensure a resistant hold even for wires with no clamped ends.
Protection
Internal 8A Fuse, against short circuits of the load.
Control type
Push-Buttons switches. Unlimited number. No polarity sensitive
NOTES
Follow the polarity and the Connection Diagram below. Connect to Direct Current (DC).
Use cables of appropriate section.
Always provide an appropriate protection to the dimmer source.
Before installing ZDIM100 verify that your batteries are powerful enough
to supply Energy to your max load.
CHARACTERISTICS
Soft Start and Stop
ZDIM100 activates a soft start and a soft stop dimming function.
Memory
When you turn off load, ZDIM100 memorizes light intensity and when you turn on load,
ZDIM100 set the output at the same intensity.
Input voltage
10 ÷ 30 Vdc *
Full load absrption
6 A
Max load
100W@24V - 50W@12V
Absorption in Stand-by
20mA
Operating temperature
from +5°C to +50°C
Storage temperature
from -40°C to + 70°C
Housing protection
IP 20
Casing material
Self-extinguishing nylon
Certifications
CE marking according to CEI EN 60945
*
WARNING:
follow LED lamps label to power dimmer ZDIM100.
Summary of Contents for ZDIM100
Page 2: ......
