111
ENGLISH (111-501)
1
2
1
HYDR. LOCKING OF IMPLEMENTS
With this device the implement can be ATTACHED /
DETACHED using the control valve of the loader.
The cylinder hoses for the implement locking shall be
connected to the 4th function of SELECTO (fig.1). If the
hoses are switched, the locking device won't work !!
For safety reasons, there is a switch installed on the
MONO-lever remote control, or on the instrument board
of the tractor (see fig.3).
The switch shall be connected to the fixed Selecto-
connector attached on the subframe in front of the cabin
(see fig.2).
Attachment / Detachment (fig. 4)
Instructions:
- Push button D so that red is shown.
- Push button C.
- Move lever to operating position (implement function)
(fig. 4B).
After the locking / unlocking, DON'T FORGET to push
button D again.
Remark !
Regarding loaders equipped with ELECTRO DRIVE,
please note the special selector switch (for the 4th
function) on the Electro Drive control unit. Fig.5, 6
Always check, when changing implements, that the
implement is properly locked in position by pushing the
front part of the implement to the ground.
WARNING
An implement of another origin than ÅLÖ may cause
damage to the loader. Therefore never fit an implement
of another brand without making sure that the implement
is approved by ALÖ.
4
4 B
5
3
6
Summary of Contents for Q 900 Series
Page 171: ...125 125 501...
