17
ENGLISH
Nitrum / Nitrum Hybrid Rev.C
LED lights
The optional LED lights are mounted to the caster-links using
an adhesive tape and an allen screw.
The control-Box (Fig. 4.29) is clipped to the calf-straps and can
be removed for charging.
-
Switching the lights on:
by pushing the button
A
on top of
the control-Box, you can cycle through operating-modes of
the LEDs:
1. Full power mode
2. Low-power mode
3. Flash-mode
4. Off
Remove the control-box from the calf-strap:
Detach cables on the sides by gently pulling the pins out of the
connectors (C ). Now pull the control-box upwards to remove it
from the calf-strap.
Charge the battery:
Connect the USB-cable to the connector (B) on the front-side of
the control-Box. Use a standard USB-charger or your
Computer´s USB-port to charge the battery.
Battery-type
Lithium-Ion
Nominal capacity
2600mAh
Nominal voltage
3,6V
Charging-time
3hrs
Fig. 4.29
Adjust the tension of the backrest-belts
-
Tension of the backrest-belts can be continuously adjusted
using the velcro-laces
- Ex-works, the velcro-laces overlap by 20mm (Fig.4.28). This
overlap allows you to adjust slack on the backrest-
upholstery
- When further tensioning the belts, the ends can laterally
protrude. In these cases, the belts can be cut to size with a
pair of scissors. Cut the belt between the black stitchings.
The stitching will prevent the belt from fraying, Melt the
cutting edge of the belt for additional fray-protection.
Fig. 4.28
20mm
CAUTION!
When folding the backrest down, please make sure that your
fingers do not get caught.
CAUTION!
Please note that the tipping behaviour of the wheelchair will
change if the backrest angle or backrest upholstery has been
changed. This may mean that you need to use anti-tip tubes.
Summary of Contents for Nitrum
Page 85: ...85 Nitrum Nitrum Hybrid Rev C...
Page 86: ...86 Nitrum Nitrum Hybrid Rev C...
Page 87: ...87 Nitrum Nitrum Hybrid Rev C...
