31
Rev. B English
Q50 R Carbon
Checking controller:
•
Check the thin rubber gaiter or boot around the base of the
joystick shaft for damage or splitting. Check visually only, do
not handle the gaiter.
•
Make sure that all components of the control system are
securely mounted. Do not over-tighten any securing screws.
Checking controls:
•
Switch on the hand control – Do the lights flash? This
signifies that there is a fault in the electronic system. Refer
to chapter 9 for basic troubleshooting
•
Operate all of the electric options, including lights and
indicators, (if fitted), to make sure that they work correctly.
•
With the seating in an elevated position, drive the
wheelchair to make sure that the ‘creep’ mode works which
will slow the wheelchair.
•
Drive the wheelchair in each of the drive profiles to make
sure the wheelchair performs as it did before.
WARNING!
•
If you are in any doubt about the performance
requirements of your wheelchair contact your Sunrise
Medical authorised dealer.
•
After performing any maintenance or repairs on the
wheelchair you must make sure that it is functioning
correctly before it is used.
•
A complete inspection, safety check and service should be
made by a Sunrise Medical authorised dealer at least once
per year.
•
All fasteners must be replaced like for like using the correct
length, tensile strength and materials.
•
When replacing self-locking nuts, or nuts/studs secured
with a thread locking solution, ensure that a suitable thread
locking solution is reapplied to the fastener.
•
Check all Velcro fastening straps for correct adhesion when
pressed together.
•
Ensure that any contamination, such as fluff, hair, etc is
removed from the Velcro straps. Such contamination may
affect adhesion.
Monthly checks
Perform the monthly check routine before driving as described
below.
•
All fasteners should be checked monthly for wear, such as
loose bolts or broken components.
•
Check all straps monthly for fraying, ripped seams or other
indications of excessive wear damage. Discontinue use if
damage is found.
8.2 Tyre maintenance and pressures
8.2.1 Tyre wear
When inspecting the tyres for signs of wear, look for significant
scuff marks, cuts and a diminished tyre tread. Wheels will
need to be changed when the tread cannot be seen over the
complete surface of the tyre, (Fig.8.2).
Fig. 8.2
Summary of Contents for Q50 R Carbon
Page 77: ...77 Rev B Q50 R Carbon...
Page 78: ...78 Rev B Q50 R Carbon...
Page 79: ...79 Rev B Q50 R Carbon...
