ENGLISH
XENON 2 FF 24
Rev.2.0
6.6 Backrests
To adjust the back angle, please undo the Allen srew (1) and
remove it. Set the desired position and then refit the Allen screw
in this position and tighten it to the given torque. (Fig.6.6.1).
Folding backrest
To make it easier to transport the wheelchair, the top half of the
backrest can be folded down.
To do this, press both levers (1) and fold the backrest down.
When folding the backrest back up, please make sure that both
sides are firmly interlocked (Fig.6.6.2 to Fig.6.6.3).
WARNING!
•
Risk of injury: do not get your fingers caught in the folding
back mechanism.
Adjustable back sling
The adjustable back sling can be adjusted for tension by using
several straps, (Fig.6.6.4).
Height-adjustable backrest
The backrest may be set to various back heights, in 2.5 cm
steps (4 adjustment ranges: 25-30 cm, 30-40 cm,
40-45 cm and 45-47,5cm).
Remove the side pads of the upholstery and if necessary the
backrest belt covering the screws.
Release the screw (1) and set the backrest to the desired
height, then tighten the screws again, (Fig.6.6.5).
See the page on torque.
CAUTION!
Please take into account the altered centre of gravity
when setting the angle of the backrest.
6.7 Headrests
Headrests
The headrest (Fig. 6.7.1) can be raised and moved horizontally
both forwards and backwards.
To do this, loosen the screw (1,2 or 3).
Now you can adjust to the desired position. Tighten screws
again (see the page on torque).
Fig.6.6.1
1
Fig.6.6.2
Fig.6.6.4
Fig.6.6.3
1
Fig.6.7.1
3
1
2
Fig. 6.6.5
1
