Quicksilver 675WE —
General Information
14
The deck drains provide self
-
bailing capabilities while the
boat is static in the water and no passengers on board. This
prevents accumulation of water in the cockpit.
14.
Dash Layout
SC1000 tachometer
SC1000 speedometer
Helm switch panel
Helm steering
Helm breaker panel
Please note that operator vision from the helm may be obstructed by high trim angles of the craft,
along with other factors such as outboard engine trim angles, hull trim plane angles, loading and load
distribution, speed & acceleration, transition from displacement to planing mode, sea conditions, rain
and spray, darkness and fog, interior lights, position of tops and curtains, and persons or movable
gear in the operator
’
s field of vision.
Dash Switch Panel
Horn
Forward bilge pump
Aft bilge pump
Depending on the type of boat, you may have underwater
fittings that need drain plugs. Garboard drain plugs need to
be in place before the boat goes in to the water. Any fitting
that will be underwater needs to be plugged or the seacock
needs to be closed.
Navigation lights
Wiper
Windshield washer fluid
Air temperature sensor
Engine key
Lanyard switch
Engine throttle shift control
GPS
Windlass control
Zipwake controls
Stereo
Active trim keypad
Bow thruster control
Standard components
Optional components
Summary of Contents for 675WE
