Build fuel tank cap with the following
(1) Fuel Tank Stopper, (2) Fuel Tank
Plates, (3) Stainless Fuel Tank Lines,
(1) Fuel Tank Clunk, (1) M3-25
Stainless Cap Head Bolt
There are three (3) lines (Aluminum
fuel tubing) that need to be constructed
for the tank assembly. Depending on
the engine you use, you may need only
two (2) lines. One line is the fuel pick-
up line and requires a length of silicon
fuel tubing running from end of alum.
Tube to clunk – which should be
centered in tank. The other line is
pressure-line, which should be bent to
reach the top of the tank on the inside.
The third line will generally be plugged.
Tighten rubber stopper screw – but do
not over tighten or you will ruin rubber
stopper!
Step 2 – Throttle Servo & Switch Installation
Install throttle Servo using (4) M3-12
Cap Head Bolts and (4) M3 Lock Nuts