Install (1) M3 Flybar using (2) M3-5-1
Spacers, (2) Completed Flybar Control
Arms, and (2) M3-3 Set Screws.
Note:
Slide Flybar into Seasaw add (2)
Spacers on each side, next slide the
Flybar Control Arms on each side with
the arm facing the clockwise rotation.
Tighten the arms in place with the M3
Set Screws when the Flybar is
centered (same distance exposed on
each side of the rotor head) and the
arms are in parallel to each other.
Replacement Part #:
Flybar – QUISP14
Flybar Paddles - QH360
Install (2) Flybar Paddles by threading
them on to the M3 Flybar 23-25mm.
Note:
??
The Paddles must be threaded
on the same distance and must
be parallel to the Flybar Control
Arms.
??
The short sides of the Paddles
are the leading edge.
??
The Distance must be the same
from the paddle to the control
arms must be the same.
Install Completed Rotor Head to the
Main Shaft using (1) M3-20 Cap Head
Bolt and (1) M3 Locknut.
Attach (2) M4-30 Cap Head Bolt and
(2) M4 Locknut in the Drag Bolt Hole.
