Section 7 – Linkage & Final Setup
Parts List
Bag 7
2.3-15 Stainless Steel Rod X 2
2.3-30 Stainless Steel Rod X 1
2.3-35 Stainless Steel Rod X 3
2.3-50 Stainless Steel Rod X 1
2.3-80 Stainless Steel Rod X 1
2.3-85 Stainless Steel Rod X 2
Medium Ball Links x 20
Short Ball Links x 2
M2-8 Phillips Screws (Shim-ball) X 6
Shim-balls X 6
2.3 Tail Control Rod Ends X 2
Tail Control Rod Guide A X 3
Tail Control Rod Guide Insert A X 3
Tail Control Rod Guide Insert B X 3
M3-8 Cap Head Bolts X 4
M3-15 Cap Head Bolts X 4
Rubber Canopy Grommets X 4
40mm Canopy Standoff X 2
28mm Canopy Standoff X 2
Loose in Box
Carbon Tail Control Rod X 1
Fiberglass Canopy X 1
Step 1 – Linkage Rod Setup
In the following table the linkages will
be measured center to center as per
the picture. The table explains the
amount of rods you need to make and
which ball links to use on each end.
This will get the helicopter close to
finished setup, as always you will need
to make some final adjustments to
maximize the performance of your
Helicopter
Replacement Part #:
Linkage Rod Set – QCL350
All Linkages available individually just
know the size
