Operation Manual - Port
Quidway S3000-EI Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Huawei Technologies Proprietary
1-2
z
ll-duplex) and
auto
(auto-negotiation) and its speed can be set
The
desc
1.2 Ethernet Port Configuration
z
Enter Ethernet port view
string for Ethernet port
et port
r Ethernet port
sion ratio
Ethernet port
rt
s information
1.2.1 Ente
rnet port, enter Ethernet port view first.
Perform the following configuration in system view.
(auto-negotiation) and its speed can be set to
100
(100Mbps) and
auto
(auto-negotiation).
Gigabit Ethernet port operates in gigabit full-duplex mode. The operating mode
can be set to
full
(fu
to
1000
(1000Mbps) and
auto
(auto-negotiation). 1000Base-T Ethernet port
operates in 1000M full-duplex, 100M half-duplex/full-duplex, and 10M
half-duplex/full-duplex modes.
configurations of these Ethernet ports are basically the same, which will be
ribed in the following sections.
Ethernet port configuration includes:
z
Enable/Disable Ethernet port
z
Set description character
z
Set duplex attribute for Ethern
z
Set speed for Ethernet port
z
Set cable type for the Ethernet port
z
Enable/Disable flow control fo
z
Set Ethernet port broadcast suppres
z
Set link type for Ethernet port
z
Add the Ethernet port to specified VLANs
z
Set the default VLAN ID for the
z
Set loopback detection for the Ethernet po
z
Set the time interval of calculating port statistic
r Ethernet port view
Before configuring the Ethe
Table 1-1
Enter Ethernet port view
Operation
Command
Enter Ethernet port view
interface
{
interface_type
interface_num | interface_name
}
1.2.2 Enable/Disable Ethernet Port
The following command can be used for disabling or enabling the port. After configuring
the related parameters and protocol of the port, you can use the following command to
