Operation Manual - Port
Quidway S3000-EI Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Huawei Technologies Proprietary
1-6
Table 1-8
Set Ethernet port broadcast suppression ratio
Operation
Command
Set Ethernet port broadcast suppression ratio
broadcast-suppression
ratio
Restore the default Ethernet port broadcast
suppression ratio
undo broadcast-suppression
By default, 100% broadcast traffic is allowed to pass through, that is, no broadcast
suppression will be performed.
1.3.6 Set link type for Ethernet port
Ethernet port can operate in three different link types, access, hybrid, and trunk types.
The access port c
LAN only, used for connectin
’s computer.
T
L
ts on
m
e switches. The hybrid port can also
c
VLAN and receive/send the
for
necting both the switches and user’s computers. The difference between the hybrid
d the trunk port is that the hybrid port allows the packets from multiple VLANs to
Perform the following configuration in Ethernet port view.
Table 1-9
ort
arries one V
g to the user
he trunk port can belong to more than one V AN and receive/send the packe
ultiple VLANs, used for connection between th
arry more than one
packets on multiple VLANs, used
con
port an
be sent without tags, but the trunk port only allows the packets from the default VLAN to
be sent without tags.
Set link type for Ethernet p
Operation
Command
Configure the port as access port
port link-type
access
Configure the port as hybrid port
port link-type
hybrid
Configure the port as trunk port
port link-type
trunk
Restore the default link type, that is, the access port.
undo port link-type
You can configure three types of ports concurrently on the same switch, but you cannot
switch between trunk port and hybrid port. You must turn it first into access port and
ure a trunk port directly as
and then as hybrid port.
By default, the port is acc
1.3.7 Add the Ethernet port to Specified VLANs
T
ding an Ethernet p
The
a
one VLAN, while the hy
an be
added to multiple VLANs.
then set it as other type. For example, you cannot config
hybrid port, but first set it as access port
ess port.
he following commands are used for ad
ort to a specified VLAN.
ccess port can only be added to
brid and trunk ports c
