Operation Manual - Port
Quidway S3000-EI Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Huawei Technologies Proprietary
1-8
Operation
Command
Restore the default VLAN ID of the hybrid
port to the default value
undo port hybrid pvid
Restore the default VLAN ID of the trunk port
to the default value
undo port trunk pvid
Note that:
z
The Trunk port and isolate-user-vlan cannot be configured simultaneously, while
configured. However, if the
ot modify the default
oved.
z
To guarantee the proper packet transmission, the default VLAN ID of local hybrid
port or Trunk
be identical with that of the hy
runk port on
B
r
ss port
is
1.3.9 Set lo
o
ng commands are used for enabling the port loopback detection and setting
etection interval for the external loopback condition of each port. If there is a loopback
the switch will put it under control.
Table 1-12
the hybrid port and isolate-user-vlan can be thus
default VLAN has been mapped in isolate-user-vlan, you cann
VLAN ID until the mapping relationship has been rem
port should
brid port or T
the peer switch.
y default, the VLAN of hybrid port and trunk po t is VLAN 1 and that of the acce
the VLAN to which it belongs.
opback detection for the Ethernet p rt
The followi
d
port found,
Perform the following configuration in corresponding view.
Set loopback detection for the Ethernet port
Operation
Command
Enable loopback detection on the port (System
w/Ethernet port view)
loopback-detection enable
vie
Dis
tection on the port (System
view/Ethernet port view)
undo loopback-detection
able loopback de
enable
Enable the loopback controlle
trunk and hybrid ports (System
d function of the
view/Ethernet port
view)
loopback-detection control
enable
Disable the loopback controlled function of the
trunk and hybrid ports (System view/Ethernet port
undo loopback-detection
view)
control enable
Set the external loopback detection interval of the
port (System view)
loopback-detection
interval-time
time
Restore the default external loopback detection
interval of the port (System view)
undo
interv
loopback-detection
al-time
