•Do not run the unit in COOL&humidity mode with stale water in the tank. You must empty
the water tank and refill it with fresh water, especially if the tank has not been cleaned in a
long time.
•The cleaning frequency for the Honeycomb & humidifiermedia depends on local air and
water conditions. In areas where the mineral content of water is high, mineral deposits may
build up on the Honeycomb Cooling Media &humidifer filter and restrict the performance.
Draining the water tankand refilling it with fresh water at least once a week will help reduce
mineral deposits. If mineral deposits remain on the Honeycomb Cooling Media&humidifer
filter, the media should be removed and washed under fresh water. The media should be
cleaned every two months or sooner, depending on your needs.
•For best results allow the Honeycomb Cooling Media&humidifer filter to dry after each use
by turning offthe cool function 15 minutes before turning the unit off.
Removing the carbon dust filter*/ honeycomb cooling
Cartridge/humidity PP filter cartridge:
1. Carefully remove the rear grill from the unit.
2. Remove the 3 band holders to release the carbon
dust filter.
3. Rinse the filter with clean water and let it dry before
re-installing to the rear grill.
4. Pull out the Honeycomb cooling cartridge/humidifier
filter cartridge.
5. Replace or clean media with water and a damp cloth
as needed.
Clean Smart sensors detector
Clean the smart sensor detector every two months to make sure the purifier runs at optimal
performance levels. If the purifier is used in a dusty environment, please clean it more often.
Warning:
Only the carbon filter/Honeycomb cooling media cartridge /Humidity PP filter can be cleaned
by water. The HEPA filter can not be cleaned with water.
Warning:
DO NOT operate the machinewhen the Rear Grill is removed from the machine, or if there is a
loose-fitting Rear Grill. Doing so can cause serious injury or dangerous electrical shock.
HC/HU/HP
cartridge
Carbon
filter
Rear
grill
17
