Putting into Operation
EWS 20
• Remove cap and aerosol filter mat.
• Fill fresh water into EWS until water comes
out of the outlet.
• Wait for 24 hours, top up with water if
required.
• Put back cap and aerosol filter mat.
The EWS 20 emulsion separator is now ready
for operation.
The treated water may initially have a dark color.
This will be momentary, and can be discharged
to sanitary sewer.
EWS 100
• Remove the lid.
• Check if plastic bag around the cartridge has
been removed!
• Pour water in top.
• Shut off the water when it starts to come out
at the water outlet.
• Wait for 24 hours, top up with water if
required.
• Put lid back on.
The EWS 100 emulsion separator is ready for
operation:
• Feed in condensate
The treated water may initially have a dark
color. This will be momentary, and can be
discharged to sanitary sewer.
Checking for Leaks
• Inspect hoses and connections, tighten
screws where necessary or replace parts.
• Container - Contact QUINCY in the event
of leakage.
H
2
O
H
2
O
10
Quincy Compressor-EWS Emulsion Separator
