ENGLISH
4 - Edition 10/2014 Cod. 2200780113 01 -
8.0 POSITION OF PLATES
8.1 POSITION OF THE DANGER PLATES (Fig. 4)
The plates fitted on the compressor unit are part of the machine; they have been applied for safety purposes and must not be removed or
spoiled for any reason.
Ref.1 - Spare plate Code 1079 9926 55
8.2 POSITION OF THE DATA PLATES (Fig. 4)
Ref. 2) “IN”
Ref. 4) Identification plate
Ref. 3) “OUT”
9.0 DRYERS ROOM
9.1 FLOOR
The floor must be even and of industrial type; the total weight of the machine is shown in Fig. 5
Remember the total weight of the machine when positioning it.
9.2 VENTILATION
The choice of an appropriate room will prolong the life of your dryer; the room must be spacious, dry, well ventilated and free from dust.
The operating conditions to be complied with are the following:
Min. room temperature: + 34 °F (+ 2 °F) compulsory
Min. temperature of incoming air: + 34 °F (+ 1 °C)
Max. room temperature: + 115 °F (+ 46 °C) compulsory
Max. working pressure: 232 psi (16 bar)
Max. temperature of incoming air: + 131 °F (+ 55 °C)
10.0 TRANSPORT AND HANDLING
The machine must be transported as shown in the following fig. 5.
11.0 UNPACKING
CUTTING THE METAL STRAPPING IS A DANGEROUS OPERATION, DO NOT ABANDON THE CUT PIECES IN THE ENVIRONMENT.
After removing the packing, ensure that the machine is unbroken and that there are no visibly damaged parts.
If you are in doubt, do not use the machine but apply to the manufacturer technical assistance service or to your dealer.
The packing material (plastic bags, polystyrene foam, nails, screws, wood, metal strapping, etc.) must not be left within the reach of children
or abandoned in the environment, as they are a potential source of danger and pollution.Dispose of these materials in the approved
collection centres.
12.0 INSTALLATION
12.1 POSITIONING
After unpacking the equipment and preparing the dryers room, put the machine into position, checking the following items:
ensure that there is sufficient space around the machine to allow maintenance (see Fig. 6).
ENSURE THAT THE OPERATOR CAN SEE THE WHOLE MACHINE FROM THE CONTROL PANEL AND CHECK THE PRESENCE OF ANY
UNAUTHORIZED PERSONS IN THE VICINITY OF THE MACHINE.
12.2 ELECTRICAL CONNECTION
Check that the supply voltage is the same as the value indicated on the machine data plate.
Check the condition of the line leads and ensure that there is an efficient earth lead.
Ensure that there is an automatic cut-out device upstream for the machine against overcurrents, with a differential device ( Ref.
1 Fig. 6 ), wiring diagram.
FIG. 5
MODD.
GROSS WEIGHT
lb. (Kg.)
QPNC 10
57,3 (26)
QPNC 15
59,5 (27)
QPNC 25
70,5 (32)
QPNC 35
75,0 (34)
QPNC 50
75,0 (34)
1
1079 9926 55
FIG. 4
2
3
4
