Unfolding / folding (see illustrations 1 - 13)
To unfold
• The frame has been secured by means of a transport safety lock to prevent it from unfolding during transport.
Release the lock by pulling the left handlebar safety lock in the direction of the arrow (1).
• Pull the handlebar upwards (2) until it "clicks" into the handlebar safety lock (3).
• Check this by pushing down on the handlebar.
• Make sure that the handlebar safety locks are released (4,1).
• Adjust the handlebar to the desired height (4,2).
• Click both handlebar safety locks back into place (5).
Placing / removing the wheels
• The 2 wheels with the brake cylinder should be mounted as rear wheels.
• Press the button in the middle of the hubcap (6/10) while pushing the axle into the axle opening (7).
• Check to make sure the wheel is secure.
• Place the wheel into the front fork by pressing the button (8,1) and then clicking the wheel into the opening on
the front (8,2).
• The swivel wheel can be adjusted into 2 different positions: fixed or swivelling (9,1). To lock it into the fixed
position, rotate the swivel lock until 2 straight arrows appear in the display (9,2).
• The swivelling front wheel will lock itself the moment the pushchair is pushed forward.
• Check the tyre pressure and inflate the tyre if necessary (see maintenance section for the maximum tyre
pressure allowance).
• To remove the rear wheels, press the button on the hubcap (6/10) and pull the wheel out of the axle opening (11).
• To remove the swivel wheel, press the button and pull the wheel out of the axle opening.
Folding
• IMPORTANT: The swivel wheel must be in a swivelling position before folding (9,1).
• IMPORTANT: Always remove the Dreami carrycot or Maxi-Cosi car seat before folding.
• Apply the brake on the Speedi SX (see Using the parking brake).
• Fold up the sun canopy (see Using the sun canopy).
• Make sure the footrest is in the lowest position (see Footrest).
• Click open both handlebar safety locks (12,1).
• Push in the release button on the handlebar (12,2).
• Push down the handlebar until the stop (13), and then further downwards until you hear a clearly definite "click".
• Make sure the transport safety lock clicks over the catch again.
• Remove the wheels to make the pushchair even smaller.
• IMPORTANT: It is advisable to remove the sun canopy before folding the pushchair (see Using the sun canopy).
INSTRUCTIONS FOR USE
For use with the Dreami carrycot (up to 9 kg) and the Maxi-Cosi car safety seat (up to 13 kg) (see illustrations 14 - 16)
Placing / removing the adapters
• Remove both guards by pushing in the button (14,1) whilst simultaneously pushing the guards upwards
(14,2).
• Slide the adapter marked R into the right-hand side and the adapter marked L into the left-hand side of the
adapter attachment.
• Continue sliding until you hear a "click" (15).
• Check to make sure the adapters are secure.
• To remove the adapters, push in the spring-loaded button (16,1) whilst simultaneously pushing the adapters
upwards (16,2).
• Place both guards back onto adapter attachments.
I N S T R U C T I O N S F O R U S E
8 /
GB
