Release: 06 / 2019
Scanner Settings
In the "Reference Scan" window, you must set the data of the QuinsBox once!
Scan Systems Settings / Adjustment
In the top line, the correct Quins Box type, "Scan System"
must be selected, so that the scan program accesses the
correct hardware driver.
The "Map" settings are only intended for the old Quins boxes
LC10 / 100, for the current types of the LC20 / LC25 and LCM20
series these parameters have to be deactivated!
In this window, the dimensional accuracy
is entered. Take over the values of the "Adjustment" label which is set
on the right side of your Quins box.
Please note:
if you reinstall the Quins software, or if you connect another Quins box
to the system computer, these entries
page - 7 -
Scanner Settings
In the "Reference Scan" window, you must set the data of the QuinsBox once!
Scan Systems Settings / Adjustment
In the top line, the correct Quins Box type, "Scan System"
must be selected, so that the scan program accesses the
The "Map" settings are only intended for the old Quins boxes
LC10 / 100, for the current types of the LC20 / LC25 and LCM20
series these parameters have to be deactivated!
In this window, the dimensional accuracy of the connected Quins box
of the "Adjustment" label which is set
if you reinstall the Quins software, or if you connect another Quins box
entries must be corrected accordingly!
