4-22 Repair/Replacement and Calibration
MedTrack CR60 Rehabilitation Treadmill Service Manual
Field Functional Test
To verify that the treadmill is operating properly, perform “Field Test No.
3” on page D-5.
Replacing Compression Mounts
Inspect the compression mounts each time you change the walk belt.
Replace the mounts, if worn.
1. Remove the deck as explained in “Replacing the Walking Belt” on
2. Locate and unscrew the compression mounts from the inside of each
siderail. There are five long mounts and four short mounts on each
siderail. The front two mounts are attached with hex nuts underneath.
3. Unscrew the mounts from each siderail and replace.
4. Replace the deck as described in the next section.
Field Functional Test
To verify that the treadmill is operating properly, perform “Field Test No.
3” on page D-5.
Replacing the Deck
♦
The deck is reversible. You can turn it over if one side wears out.
Follow steps 1 through 7 in “Replacing the Walking Belt” on page 4-21 to
remove and replace the deck.
Field Functional Test
To verify that the treadmill is operating properly, perform “Field Test No.
3” on page D-5.
L
S
L
S
L
S L
S
L
Aluminum spacer
S = Short Mounts
L = Long Mounts