ITA-200 Technical Reference Manual Rev 1.0
___________________________________________________________________
_____________________________________________________________________________________
Copyright © 2004-2006 Quintum Technologies, Inc. All Rights Reserved
11 of 58
Chapter 3
Connecting the ITA-200
Connect the ITA-200 Cables
a) Connect the RJ-45 Ethernet cable provided with the ITA-200 between the Ethernet port of
your broadband modem (Cable/ DSL Modem) and the WAN port of the ITA-200.
b) Connect your PC’s Ethernet port to the LAN port of the ITA-200 using the other RJ-45
Ethernet cable.
c) Connect Phone1 port of the ITA-200 to a telephone or fax machine using a standard RJ-11
telephone cord. Repeat the same step for the Phone2 port.
Remarks
: The telephone must be configured for tone dialing rather than
pulse dialing in order for the ITA-200 to operate properly.
d) Connect the +12 volts AC Power Adapter to the power socket in the rear of ITA-200.
Connect the AC plug end of the power adapter to an electrical wall outlet. The complete
setup should look like Figure 4 shown below.
Important
: Only use the power adapter supplied with the ITA-200. Using a
different adapter may result in product damage.
Figure 4. ITA-200 Interconnection