P/N 480-0049-00-13
3-11
Chapter 3: Installation
Power up the System
Once you have all cables connected properly, you are ready to turn the system on as follows:
1. Plug in the power cord to an AC outlet.
2. Locate the on/off switch on the back of the unit and click the switch to
On
.
The unit will power up and the LEDs will flash and turn off; the power LED will remain lit. For information
about the LEDs, see
Chapter 2: Hardware Components
.
Once the unit is powered up, you are ready to assign an IP address. See the following section
Assign IP
Address
.
