P/N 480-0049-00-13
4-3
Chapter 4: Getting Started: Tenor Configuration Man-
Tenor Configuration Manager
The
Tenor Configuration Manager
is used to configure all aspects of the
Tenor DX
, including system, Ether-
net, CDR, signaling, circuit, and VoIP configuration. Through the
Configuration Manager,
you are able to
configure all aspects of the Tenor unit.
The manager is a user-friendly GUI which enables you to configure Quintum products; you designate the IP
address of the Tenor product you want to configure. A menu tree—which displays all configuration options in
the system—is divided into four main areas:
System Wide Configuration
,
Ethernet Configuration, VoIP Con-
figuration,
and
Circuit Configuration.
•
System Wide Configuration.
The configuration items under
System Wide Configuration
include chassis,
dial plan, and assorted server information.
•
Ethernet Configuration.
The
Ethernet Configuration
menu includes options for configuring Ethernet
interface information as well as Static IP, NAT IP and Filter IP information.
•
VoIP Configuration.
The
VoIP Configuration
prompt contains the major sub-prompts for configuring the
parameters which pertain to its VoIP element status, such as Gateway, Gatekeeper, Border Element, and
Signaling Group.
•
Circuit Configuration.
Through the Circuit Configuration options, you are able to set auto-switch, sig-
naling, and trunk group information.
Getting Started with Configuration
This section gives instructions for getting started with the
Tenor Configuration Manager.
For detailed infor-
mation about the installation procedure, see the
Tenor Configuration Manager/Tenor Monitor User’s Guide.
NOTE:
As an alternate to configuring via
Tenor Configuration Manager,
you can configure the unit via
Command Line Interface (CLI)
. For information about the CLI, see
Chapter 5: Getting Started:
Command Line Interface (CLI)
or the
Command Line Interface User Guide
you received with the
unit.
NOTE:
Ensure the software is installed and running.
1. Access the
Tenor Configuration
Manager
icon (located in the area in which you specified during installa-
tion). For example, click on
Start > Programs >Quintum Tenor Configuration Manager> Tenor Config
Manager.
The
Tenor Configuration Manager
will launch. The
Specify Tenor IP Address
window will be
displayed.
2. From the
Tenor IP Address
drop down box, click on
Specify New IP Address
(if the IP address is already
listed from a previous login, select that IP address and you will automatically be connected).
3. Enter the IP address of the Tenor unit in which you would like to configure.
4. Enter the Tenor Server Port (the value must match the port numbers set via CLI; the default entry is
8080
).
5. Click Ok. The
Confirm Login and Password
screen will be displayed.
6. Enter a user name and password (the default user name is
admin
; the default password is
admin
). Click
ok
. You are now ready to configure the Tenor unit.
