Technical description |
EN
2.3 Keys
The network node has 3 buttons with the following functions:
•
DISPLAY
: Key (11) for switching the display and for acknowledging errors.
•
MODE
: Key (10) for switching the installation mode on or off. If an extended mode is active, this key is used to
switch back to the standard mode. After activation of the infrared interface (IR), the LED on the front panel flashes.
•
RESET
: Recessed key (7) to trigger a network reset (interruption of all connections between the network nodes).
2.4 Extension module for RNN5
000M
1x
(13)
RS232 interface
(14)
Connector to the main board at pos. 2
(15)
Connector for voltage supply DC 3.6 V at
pos. (3)
2.5 Display levels
-
Current operating mode (Mode)
A
Alternate Q
node
5.5 number (primary address) and network number
B
Number of Q
node
5.5 on the network
C
Number of consumption meters in the network
D
Remaining capacity of the main battery of the Q
node
5.5 as a percentage
E
Error codes (three groups)
F
Compatibility
Supports Q AMR S-Mode + Q AMR C-Mode + Ei6500-OMS (extended upward compatible)
Supports Q AMR S-Mode + Q AMR C-Mode (upward compatible)
Supports only Q AMR S-Mode with WTT16, Q
node
5 and Q
node
5.5. No Q AMR C-Mode
(backward compatible).
09.03.2023
56
