1 Connect the CO₂ pressure reducing
valve
Push the clear CO₂ hose provided into the
push fit connection on the CO₂ pressure
reducing valve.
2 Connect the CUBE unit
Remove the protective cap from the push
fit CO₂ connection at the rear of the CUBE
and push the CO₂ hose into the coupling.
3 Connection to the CO₂ cylinder
Hold the CO₂ pressure reducing valve
vertically. Remove the protective cap
and screw the cylinder into the CO₂
pressure reducing valve until it cannot be
tightened any further. It is important that
it is thoroughly tightened so that a tight
seal is formed. Some gas may escape
and a hissing noise may be heard. This is
perfectly normal, but it is important that you
ensure the cylinder is tightly screwed in.
4 Positioning of the CO₂ cylinder
Once the CO₂ cylinder has been screwed
firmly into the CO₂ pressure reducing
valve, attach it onto the top edge of the
CUBE. The cylinder can be hung on the
front or on either side of the CUBE.
1
3
2
4
Connect the CO₂ cylinder
• Please note: The CO₂ cylinder is pressurised.
• Please note: The CO₂ cylinder must be suspended on the side of the CUBE tank.
The CO₂ cylinder must never lie horizontal.
C
CO
2
IN
