6. COMPLETING
THE
INSTALLATION
1.
Make sure the wiring is safely inside the
outlet box as instructed in
Step 5 -
Electrical Connections.
To install the
canopy, slide the canopy up to hanger
bracket and place the key hole on the
canopy over the screw on the hanger
bracket, turn canopy until it locks in place
at the narrow section of the key holes. (Fig.
10) Align the circular hole on canopy with
the remaining hole on the hanger bracket,
secure by tightening the two set screws, lift
canopy cover and attach by turning
clockwise.
Note:
Adjust the canopy screws
as necessary until the canopy and canopy
cover are snug. (Fig. 10)
2.
Blade Assembly & Installation (Fig. 11)
Align holes from blade, blade support plates
and motor housing and secure with blade
attachment screw. Repeat steps for the
remaining blades.
DO NOT bend the
blade arms when installing the blades.
3.
Attaching the Decorative Plate
Attach the mounting plate A to the
mounting ring of the motor by using the
three screws provided that are pre-installed
on the mounting ring. (Fig. 12)
Attach the mounting plate B to the
mounting plate A by using the three screws
provided . (Fig. 13)
Raise decorative plate up against mounting
plate B and secure it to the fan by turning
clockwise until snug.provided. DO NOT
OVER TIGHTEN. (Fig. 14)
A certain amount of wobble may be
considered normal, especially if the fan is on a
downrod long than 12".
Fig. 11
Fig. 13
Fig. 12
Fig. 14
Fig. 10
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
Screws
Screws
Blades
Blade
support
plates
Screws
Mounting ring
Mounting
plate A
Screws
Mounting
plate A
Mounting
plate B
Mounting
plate B
Decorative plate
