5. ELECTRICAL CONNECTIONS
REMEMBER
-Turn off the power!
Use the wire nuts supplied with your fan
when making connections. Secure the
connectors with electrical tape and make
sure there are no loose connections or wire
strands.
1.
Spread the wires apart so that the black
wire from the fan is on one side of the
mounting bracket and the white wire and
green ground wire are on the other side.
2.
(Fig. 8) Connect the BLACK building
supply wire to the BLACK fan wire.
Connect the WHITE building neutral wire
to the WHITE fan neutral wire. Connect
the COPPER building ground wire to the
GREEN fan ground wire.
3.
Inside the ceiling junction box be sure
to spread the wires apart so that the black
connection is on one side of the outlet box
and the white/white and green/copper
connections are on the other side.
4.
Connect the wiring from the wall
switch receptacle to wall transmitter unit.
Remove the existing wall plate and
switch from the wall junction box.
Connect one BLACK wire from the
wall to one BLACK wire (labeled "TO
FAN") from the wall transmitter.
Connect the other BLACK wire
(labeled "TO POWER SUPPLY")
from the transmitter to the remaining
BLACK wire from the wall (A/C
supply source).
If your junction box has a ground
wire (green or bare copper), connect
the transmitter's ground wire to it.
Otherwise, connect the transmitter
ground wire directly to one of the
screws from the outlet box.
Carefully tuck the connected wires
inside the junction box. Secure the
transmitter with the two screws
provided. Attach the face plate over
the transmitter with the two screws
provided.
5.
Inside the ceiling junction box be sure
to spread the wires apart so that the black
connection is on one side of the outlet box
and the white/white and green/copper
connections are on the other side.
Use
ONLY
wall controls approved by
Quorum. Use of unapproved wall
controls will cause unacceptable
humming noise, and avoids the fan
warranty.
Hook up in "series only" do
not
connect
the hot and neutral wires of electric
circuit to the transmitter wall switch -
damage to the switch and possible fire
could occur.
Fig. 8
Fan canopy
Outlet box
Wall control
Ceiling
WH
WH
BLK
BLK
BLK
House
supply
wire
GRN
GROUND
NOTE:
It may be necessary to bind
the house wires to the corresponding
receiver wires with electrical tape
before capping them with wire nuts.
This will prevent them from slipping
apart during the rest of the installation.
