Fig. 7
Downrod
Hanger bracket
WARNING -
Turn off the power!
DO NOT fasten the blades to the fan until
it is assembled and hanging from the
ceiling. To do so now will likely bend the
blade arms and almost certainly cause
wobble.
CAUTION: Remove 5 rubber packing
mounts from fan motor assembly and
discard before installation.
1.
If not already affixed to the hanger
bracket, place the rectangular rubber isolators
between the hanger bracket and outlet box.
Secure the hanger bracket to the outlet box
using the 2 long steel screws supplied with
the outlex box.
2.
Remove the set pin and safety lock clip
from the yoke on top of the motor assembly.
Slide the downrod through the canopy. (Fig.
5). Feed the wires from the fan motor
through the downrod assembly.
3.
(Fig. 6) Attach the downrod assembly
(downrod and canopy) to the motor by
sliding the downrod into the yoke on top of
the motor assembly. Slide the set pin through
the hole in the yoke, downrod and secure it
with the safety lock clip. Tighten the set
screws on yoke. Feed the wires through the
downrod ball.
4.
Lift the fan motor without the blades and
place into the hanger bracket, rotating the
ball until the groove engages the tab on the
hanger bracket. This locks the ball mount and
fan motor, preventing fan rotation during
operation. (Fig. 7)
4. HANGING YOUR FAN
Fig. 5
Fig. 6
Downrod
assembly
Ceiling
canopy
Downrod
Set screw
Yoke
Safety
lock clip
Set pin
Canopy
