For Function Buttons:
.
1
Rub the cervical part and conducting strips with a wet towel before
fitting the massager closely to your neck. Make sure your neck isn’t
sweaty.
.
2
Press the host Power Button so the indicator flashes and beeps. It
will maintain the awaiting signal state for a minute and automatically
shut down if a signal isn’t received. The following settings will be
available:
A.
Auto-combination massage
B.
Grade 0 intensity
C.
Middle temperature
D. Time: 15 minutes
.
3
Use of power Button:
When the power is off, press the Power Button to enter the
standby state and turn the massager on. Then, to turn it off, press
the same button.
.
4
Use of mode button:
With the pulse mode switch button, you can select the following six
pulse modes. It will be Mode 1 by default after the start-up.
How to Operate
For Power Supply
:
.
1
For USB power supply, insert the output and input plugs of
Micro USB Cable into the port (DC port) on the lower part of the
massager and the AC power socket respectively.
.
2
The built-in rechargeable battery can serve as the power supply
when the external power supply is not used.
.
3
Ensure proper installation of the button cell CR2032 in the remote
control, as shown below. Use a coin or straight screwdriver to
unscrew battery cover at the groove, turn the right (positive) side of
button CR2032 upwards, put it in the battery holder of the remote
control, and insert the positioning pin on the top of the battery
cover. Then press the battery cover tightly.
